Is it possible to put a security in the event of breakage or potentiometer hall effect sensor ...
if the sensor breaks, the cam could turn non stop. can there be a simulator Stop in poor position reading?
Unfortunately this will happen one day ... date, if the sim stop, this could limit the damage
one could imagine a stop mode in case of failure, and cut the engine in case of problem detection?
I do not know if this is possible?
if there exceeded the dead zone of potentiometers, cut engine if there is a misreading of the position, engine cut if there is no reading of a potentiometer, engine cut ... if the card is in mode 3 DOF, Reading 2 sensor, engine cut .... If the card is in 6DOF mode, reading 5 sensor, engine cut ...
Its possible to implement safety monitoring like this in the firmware, but how could I do them universal? I could base the monitoring in time passed without setpoint reached, 1-2 sec perhaps? Selectable delay better?
And then there is possibility to use limit switches that will cut the motion of the motor not allowing it to go beyond certain travel range... see recent thread that I describe a little bit about how to hook these limit switches...
I do not know. I launched the idea to exchange with each other and share the idea. 1 s my engine that moves 180 degrees ... I'm doing the tests with switch to slip a long time ago, and although I was breaking. too slow to switch.
we need to find a simple solution unuverselle. can be related to the dead zone. if some ms in the dead zone, cut the engines. and if no measure for some ms, cut the engines.
dureiken: Hi there, it's really quiet here someone could help me for my 6 dof project ? thanks a lot
Aug 8, 2017 15:34:46 GMT
tronicgr: dureiken Hi, Open a thread and I'll try my best to help. A little busy with Kickstarter details at the moment but I'll see what I can do.
Aug 12, 2017 11:57:42 GMT
dureiken74: I just did it
Aug 27, 2017 11:59:06 GMT
fimmy: How's the firmware going?
Sept 6, 2017 8:34:43 GMT
tronicgr: @fimmy I had to put it on hold to finalize the manufacturing of the new kickstarter controllers. I tested parts of it to ensure compliance with the new features and looks good so far. I'll get back to it soon for integration.
Sept 9, 2017 12:52:35 GMT
Theuns: Very nice design.I'm also busy with mine and changing it also to Linear Actuators with 220v Servo motors.I'm waiting for my new controllers from Thanos. If I may ask Do you have any Sketchup files of your design and willing to share it I Thanks Theuns
Sept 14, 2017 22:45:09 GMT
atayeu: Hey everyone! I'm reading up and gathering all of the intel I can find for my first motion platform. this is by far best information for creating one.
Oct 14, 2017 7:25:57 GMT
tmcnam: I must be crazy but I still can't find the blueprints to the platform by GA-Dawg. Any help would be appreciated. Thanks guys.
Mar 10, 2019 21:31:57 GMT
Trip Rodriguez: Sorry tmcnam, the shoutbox doesn't get much attention. Did you find the blueprints? They are at the VERY bottom of the extremely long first post. It says "attachments: 6DOF.zip
May 4, 2019 19:13:25 GMT
zivby: How much weight this setup can carry?
May 19, 2019 11:57:16 GMT
jeanmarcfr69: Thanos je suis francais et j'ai besoins de compléments d'information pour finaliser une installation avec 1 x AMC1280USB DELUX avec extension 3x servo motor DORNA. POurriez vous m'aider ?
Apr 12, 2021 6:58:17 GMT