fimmy
New Member
Posts: 16
|
Post by fimmy on Nov 24, 2018 19:40:50 GMT
How come all the SERVO board 6 axis output are now interlinked?
they cannot be separated?
this means lateral force , longitudinal and vertical force are all getting mixed up with one and other.
one actuator doing all different things.
i just checked with voltmeter all 6 grounds and all 6 axis outputs are linked. shouldnt they be seperate
ext 3 srvo board damaged? I think not.
the fireware need changing again. p[lease seperate the axis 1 to 6 . they should not be sharing the same information.
so angry, wasted 6 hours until figuring out that was the problem!
|
|
|
Post by hexpod on Nov 26, 2018 12:15:23 GMT
How come all the SERVO board 6 axis output are now interlinked? they cannot be separated? this means lateral force , longitudinal and vertical force are all getting mixed up with one and other. one actuator doing all different things. i just checked with voltmeter all 6 grounds and all 6 axis outputs are linked. shouldnt they be seperate ext 3 srvo board damaged? I think not. the fireware need changing again. p[lease seperate the axis 1 to 6 . they should not be sharing the same information. so angry, wasted 6 hours until figuring out that was the problem! 6dof? X-sim Settings?
|
|
fimmy
New Member
Posts: 16
|
Post by fimmy on Dec 6, 2018 8:24:00 GMT
Servo extension board V3
First of all hexpod thank you for replying.
1) I am using only 4 axis 2) A1, A2, A3, A4 are sharing each others information. If you get a multimeter and do a continuity test you can 'hear' A1, A2, A3 , A4, A5 & A6 are linked by circuit.
So for example let's say I choose A1 to do longitude (back-foward) movement. However it is also reading lateral (left-right) movement but in X-SIM I only choose A1 to do longitude so why it reading lateral date from x-sim???
I did the new firmware update before I post on here with problem.
|
|
fimmy
New Member
Posts: 16
|
Post by fimmy on Dec 9, 2018 20:39:57 GMT
the problem is A1 on the servo conditioner board. Voltage Stuck. A2 works voltage increasing/decreasing, A3 working voltage increasing/decreasing, A4 working voltage increasing/decreasing
AMC set to 4DOF as will not be doing 6DOF AMC set to old style format 41 /42 not new style because new style completely screw everything up by mixing axis data
In old style it all seems to work okay apart from A1. I think I might need to buy another board? any way to check A1?
A1 voltage shoots up to max speed voltage 10V and sits there when the game starts. 'online'
|
|
fimmy
New Member
Posts: 16
|
Post by fimmy on Dec 10, 2018 21:40:10 GMT
thank you hexpod for your help.issue resolved for now.
|
|