dirty
New Member
Posts: 2
|
Post by dirty on Nov 23, 2018 15:30:45 GMT
Hey :-) I can almost not believe that I have to post such an almost trivial question, but I seem to be stuck.... I would like to use the AMC1280 with ClearPath motors and AEAT-6012 sensors in multi turn. I have connected a single motor (N°6) and a single sensor (N°6). Now when I power up the controller it starts to run the motor in one direction. I can also see in the display bar diagram that the nr.6 sensor moves. :-) So far, so good! My problem is this: It does not recognise the limit switches. How do I wire them? Next to the reset switch is a section that says "analog limit switches". Is that correct? Which ones do I connect? Is there a convention, like Sw1=upper and Sw2=lower? Can someone help me with this?
|
|
|
Post by hexpod on Nov 27, 2018 9:41:22 GMT
Hey :-) I can almost not believe that I have to post such an almost trivial question, but I seem to be stuck.... I would like to use the AMC1280 with ClearPath motors and AEAT-6012 sensors in multi turn. I have connected a single motor (N°6) and a single sensor (N°6). Now when I power up the controller it starts to run the motor in one direction. I can also see in the display bar diagram that the nr.6 sensor moves. :-) So far, so good! My problem is this: It does not recognise the limit switches. How do I wire them? Next to the reset switch is a section that says "analog limit switches". Is that correct? Which ones do I connect? Is there a convention, like Sw1=upper and Sw2=lower? View AttachmentCan someone help me with this? Follow the thread about the missing trace in the Thanos controller. Double check if this is not the source of your issue. motionsim.freeforums.net/thread/252/firmware-2-2017-controller-support?page=7
|
|