uzi
New Member
Posts: 3
|
Post by uzi on Apr 1, 2016 10:24:36 GMT
Hi, I'm trying to have the board switch to On-line mode while the motors are off (no feedback is needed) just to test that com port commands for each axis are being sent correctly using a custom code running in Unity 3D game engine. Is it possible? attached is the configuration utility screen connected to com3 however I can't make it go on-line. maybe there's another (better) way to monitor/verify the commands are sent correctly to each axis? Thanks in advance, Uzi Attachments:
|
|
|
Post by tronicgr on Apr 1, 2016 15:44:06 GMT
Fabis's configuration utility forces the amc1280usb to offline mode to be able to send commands to it.
Its not meant to be used along the normal motion software. Fabi has another software that can bridge this utility and the motion software together. Perhaps you can ask him about it.
Thanks Thanos
|
|
uzi
New Member
Posts: 3
|
Post by uzi on Apr 1, 2016 21:26:44 GMT
Hi Thanos,
Thanks for the quick reply, I'll try message Fabi as advised.
Uzi
|
|