|
Post by phamton on Aug 8, 2015 8:49:37 GMT
|
|
|
Post by tronicgr on Aug 8, 2015 16:48:32 GMT
Hmm, I suppose you can with some additional signal conditioner. www.powtran.com/en/productpage14.htmlTo drive these servo drives you will need: 10V~+10V Unidirectional control signal from the product page: (-Analog terminals can receive signal range between -10V~+10V) To generate these signal voltages you will need three is these (for a 6DOF platform): EM-SC-01 www.controlgrips.com/electronicsdetails.php?productid=25The 6DOF ext board had 0-5v analog outputs as well that can be used with the above conditioner. And then you just set the AMC1280USB to drive the signals in Unidirectional mode (One analog output signal that contains both speed and direction information). Leandro used a signal conditioner for his Moog actuators but the conditioner was made from Moog, which could cost more that the one I suggest using here. Thanks Thanos
|
|
|
Post by phamton on Aug 8, 2015 19:47:32 GMT
thanks a lot Thanos
|
|