|
Post by iamcanadian2 on Nov 27, 2014 6:22:43 GMT
Hello this is my first post here. I have a 3dof and using actuators with MDO3 on my simulator. I have Ians BFF have been using his eletronics for some time, I have upgraded to The AMC 1280 and have the BFF working very well with fsx. Now I am trying to use Sim tools with the AMC with No limits coaster 2, I have good and correct movement in the virtual sliders and all axis set up right but it does not move the actuators correctly at all. It kind of jitters and jerks but its like I have something not set right. In the "startup output"string of interface should I have Something in there as well as the "Shut down output"? I found a Shutdown output string on forum AB<127><255><127......? On the Interface output string i have AB<Axis1><Axis2><Axis3> Output bit range 8 set to "Binary" right. Packet rate ? I have mine at 10ms
I am at my wits end with this ,like I mentioned FSx and the BFF software are perfect so its not electronics or settings in the comport that are all scewed up, its probably me and SiMTL Is anybody else using the1280 and ?
Thanks in Advance
.
|
|
|
Post by tronicgr on Nov 27, 2014 6:27:39 GMT
Try to set 16bit and binary... packet rate set it to 2ms
Happy thanksgiving...!
PS. I didn't get to finish emails yet. So I write it here...
|
|
|
Post by iamcanadian2 on Nov 27, 2014 6:34:43 GMT
Hey that was fast . Thanks you have a good holiday . we had ours already in Canada hey! So should i leave the top and bottom output string empty? Attached Pictures:
|
|
|
Post by tronicgr on Nov 27, 2014 7:01:19 GMT
Can you post a screenshot of these settings you have?
I don't use their software and not sure how it looks like there...
|
|
|
Post by iamcanadian2 on Nov 27, 2014 20:06:31 GMT
Ok so I set the suggested bit rate and played around with the PID I Have them set to 20-25. seems to work well now. thanks Thanos it must have been the 16 bit i needed. Now I can adjust the coaster. Im feeling a little oozzie to much roller coaster. now Im haven FUN!!
|
|