|
Post by vgracingse on Oct 30, 2019 16:43:08 GMT
The rig is almost done! But I got a issue with the AMC1280 board. After 5min driving the simulator doing just unwanted movement and don’t stop until I press emergency stop. After some testing I found out that there is something that getting hot on the board that’s makes the movement that the games absolutely not doing. It’s just enough to have a fan blowing on the board and it works fine. Is there anyone else who got same problem?
|
|
tony
New Member
Posts: 23
|
Post by tony on Nov 23, 2019 4:00:32 GMT
Try replacing the Udn Chips (name???). The chips that are socketed are super sensitive to static electricity. Wear a ground strap when touching the circuit board. Digi-key has replacements. Be well.
|
|
|
Post by vgracingse on Nov 23, 2019 7:51:28 GMT
More video to come!
|
|
|
Post by vgracingse on Jul 18, 2020 7:16:08 GMT
Try replacing the Udn Chips (name???). The chips that are socketed are super sensitive to static electricity. Wear a ground strap when touching the circuit board. Digi-key has replacements. Be well. Still got the issue with heat. Not replace any chip yet. Just tested a lot more. If I drive a warm day it crash immeaditely and a cold day it works better. So I try to apply heat with a hair dryer and figure out that the controller crash when I pointed the dryer to the microcontroller board (black one) . The board where the USB cable is attached. It is very sensitive. Have you been into this before or know a solution to fix this?
|
|
|
Post by vgracingse on Nov 23, 2020 21:32:00 GMT
So the problem is solved. I tested more and use a heatcamera to see exactly which part that get warm and how hot it get before it crash. 30° celsius then it crash. That was way too low when I asked Thanos. He sent me a replacement card. Now it works very good. I can close the box with heat from VFD. Never crash Anymore. Thanks a lot [mention]tronicgr [/mention]
|
|
|
Post by vgracingse on Nov 23, 2020 21:38:56 GMT
|
|