asaf
New Member
Posts: 26
|
Post by asaf on Sept 25, 2015 15:26:19 GMT
Hi, When connecting p207 it works ok. But sometimes when i run a test and motor 1 is connected, the test stops and I get a red blinking led on the 207. All motors without #1 is ok. Same during game. if motor #1 is connected. other motors start to freeze. and then, I unplug motor1 and they get free. Is it possible that the port for motor 1 is damaged ?
Thanks !
|
|
|
Post by tronicgr on Sept 26, 2015 14:29:53 GMT
Hmm, never seen this behavior before. Did you try to swap motors on #1 to see if its servo motor related?
Thanks Thanos
|
|
|
Post by Mitch on Oct 6, 2015 3:25:22 GMT
Is it still happening? Try disconnecting another motor instead and let us know what happens. They say red led is a fatal error, could be caused by bad serial data. I think it could be caused by inability to reach the set point due to insufficient current for 6 motors. Check current draw of servos and make sure you're supplying sufficient power. www.pololu.com/file/0J37/ssc03a_guide.pdf
|
|