asaf
New Member
Posts: 26
|
Post by asaf on Sept 22, 2015 17:26:26 GMT
Hi,
The mini servos sometimes gets stuck in a certain position for a moment, as does the 3d simulator.
What can cause that ?
Thanks
|
|
|
Post by tronicgr on Sept 22, 2015 17:36:41 GMT
I haven't seen it on my computer, but that freeze usually means that your computer is so occupied doing other tasks ( antivirus scanner, windows updates, other background services) that it lags to continue feed data to the 6DOF plugin. Try clean up your computer a little bit. Xsim can also run on dedicated thread if you have multithread processor on your computer.
Thanks Thanos
|
|
asaf
New Member
Posts: 26
|
Post by asaf on Sept 24, 2015 9:13:13 GMT
Thanks Thanos !
Almost every time i go through a specific corner the 3d model freezes. The control software says "Too Far !" And the motors stay on 49 and don't change, even though the bars in the control software are moving It happens in specific corners and until a specific point. i have to reset the position in the control software for it to work again
Any ideas ? I think that if i increase axis limits it helps
Thanks
|
|
|
Post by tronicgr on Sept 24, 2015 13:43:53 GMT
Ok, the plugin will calculate and prevent positions of the platform that could do mechanical damage to the structure, like crossing the rods or too much angle that will make the top platform unstable.
Can you take a pic of the plugin settings and perhaps a screenshot or video of the position it gets stuck? I may know what to to adjust to prevent it.
Thanks Thanos
|
|
asaf
New Member
Posts: 26
|
Post by asaf on Sept 25, 2015 13:47:44 GMT
Hi, The "Max Dep" limiter stopped it from moving. What does this setting control ? And what does the cross sens controls ? Thanks !
|
|
|
Post by tronicgr on Sept 26, 2015 14:33:36 GMT
These limiters prevent the platform from getting dangerous angles on the joints or crossing the rods together. I have seen platforms lock down from excessive angles before.
|
|
asaf
New Member
Posts: 26
|
Post by asaf on Sept 26, 2015 15:46:29 GMT
Thank you
|
|