asaf
New Member
Posts: 26
|
Post by asaf on Sept 21, 2015 19:17:14 GMT
Hi, i have the amc1280usb connected to the pololu 207 and one servo connected to it. the amc receives values from the pc and also from one analog sensors. on the p207 only the yellow led is on. and the servo doesnt move. even though the amc updates its values also i dont see a green led on the p207 - that indicates that data is being transfered.
any ideas ?
|
|
|
Post by tronicgr on Sept 22, 2015 1:25:02 GMT
Hi, i have the amc1280usb connected to the pololu 207 and one servo connected to it. the amc receives values from the pc and also from one analog sensors. on the p207 only the yellow led is on. and the servo doesnt move. even though the amc updates its values also i dont see a green led on the p207 - that indicates that data is being transfered. any ideas ? Did you connected a jumper on S2 (near KLM terminal)? If you don't have a spare you can borrow a jumper from the 6DOF ext board as you cannot use these both together. Also no need to connect the analog sensors for the miniservo as the Amc1280usb uses their internal sensor for positioning. I'm on mobile right now so if you could check the Dropbox file deposit for photos that show the connections for the pololu controller and the jumper. Thanks Thanos PS. Just a note to people emailing me these last 3 days, I'll get back to you as soon I get PC Internet access...
|
|
asaf
New Member
Posts: 26
|
Post by asaf on Sept 22, 2015 16:43:47 GMT
Thats exactly it !
Works like a charm, Thanks !!
Where can I find the documentation for the jumpers ?
|
|
|
Post by tronicgr on Sept 22, 2015 17:39:04 GMT
|
|