rx
New Member
Posts: 1
|
Post by rx on May 24, 2015 21:49:08 GMT
Hi Thanos,
We will be using Servomotor and Servodrives and the Omron drives we are using allow only one input for direction (VSIGN) at +24V. Would the logic of the board be able to handle using only one of the pins to drive direction? It would be +24 CW and 0 CCW (or inverse depending on settings). I would assume that pin A1 of the Digital Direction Outputs would be 0 for the reverse direction or stopped and +24 for the forward direction. Do you think this would work properly?
Thank you, Eric
|
|
|
Post by tronicgr on May 25, 2015 15:19:11 GMT
Hi Thanos, We will be using Servomotor and Servodrives and the Omron drives we are using allow only one input for direction (VSIGN) at +24V. Would the logic of the board be able to handle using only one of the pins to drive direction? It would be +24 CW and 0 CCW (or inverse depending on settings). I would assume that pin A1 of the Digital Direction Outputs would be 0 for the reverse direction or stopped and +24 for the forward direction. Do you think this would work properly? Thank you, Eric Hi Eric, Of course you can use only one of the pins for direction to be either CW or CCW when 0 or 24 volts. See the last video I uploaded about using it like that on the Clearpath servo motor I have here: If the direction is not correct you can use the other pin "B" to get the proper orientation. If your system can work with 5V as well as the servomotor on the above video, you may use the 5V signal headers on the 6DOF ext board. I drive the servomotor with PWM signals and DIR that is only 5V level. Thanks Thanos
|
|